• Commercial Courses

Vitocrossal 200 CI2 | Service/Maintenance

Products:

Vitocrossal 200 CI2

  • Intermediate
  • 5 Modules
  • 3:15 hours

Course Overview

This class is for licensed contractors or service technicians that are beginning to or have been working with the Vitocrossal 200 CI2. This class will cover detailed information of annual service and maintenance requirements, control navigation and how to utilize the Viessmann OneBase Digital Tools for remote monitoring. There will be hands on portions for boiler servicing, and control navigation. Prior experience with condensing boiler installations or service is required.

Standard Modules

  • 4 Modules
  • 3 hours
Log In
Control Navigation Exercises | Vitocrossal 200 CI2Intermediate
Log In

Log in to request courses

Hands On Training (including but not limited to):

  1. Navigating the touchscreen control
  2. Accessing fault history
  3. Accessing emissions test mode
  4. Performing emissions test
Service & Maintenance Exercises | Vitocrossal 200 CI2Intermediate
Log In

Log in to request courses

Hands On Training (including but not limited to):

  1. Removing and reinstalling burner assembly
  2. Replacing electrode
  3. Servicing condensate trap
  4. Flushing heat exchanger
Control Interface For Start Up & Commissioning | Vitocrossal 200 CI2 Cascade BoilersIntermediate
Log In

Log in to request courses

Learning Objectives: 

  1. Identify the Cascade Capabilities
  2. Describe the CAN bus Wiring Communication Protocol
  3. Explain the ViGuide Procedure for Cascade Systems


Service & Maintenance | Vitocrossal 200 CI2Intermediate
Log In

Log in to request courses

Learning Objectives: 

  1. Describe the required Annual maintenance procedure
  2. Identify the recommended chemicals and tools needed to clean the Heat Exchanger
  3. Illustrate proper combustion analysis
  4. Explain the importance of maintaining service record

Add-on Modules

  • 1 Module
  • 15 mins
Versatronik 503 Communication BridgeIntermediate
Log In

Log in to request courses

Learning Objectives: 

  1. Identify the Intended use of the Versatronik 503 Control
  2. Explain the Wiring Protocol for LON to CANbus (E-Series) Communication
  3. Illustrate the Communication Possibilities to Legacy B2HB / CM2 Models
Products Covered in this Training
  • Vitocrossal 200 CI2